top of page

DESCRIPTION

SUKHOI 29, just like all our airplanes, was designed using the latest 3D technology available, assuring a precise fit of all the parts. Priorities were a clean aerodynamic plane, together with new components and new set ups, to allow this plane to use in every aspect of flying, either F3M, IMAC or 3D.

 

As you can see, our SU 29 does have a vast fuselage side area, assuring a perfect knife-edge flight.

Throughout testing shows that SU 29 is a perfect plane not only for those who want to start to practice aerobatics but also for pilots flying in IMAC competition.

 

The way this plane is set up from our factory and staying within a recommended CG location, no need for mixing in knife edge or inverted. Snap roll stopped immediately and very crisp.

Kit includes:

Using new composite technology, we were able to come up with an extremely light airplane. And if you use a single-cylinder 85ccm engine, you get an incredible power to weight ratio.

 

High prefabrication of this ARF, and it's perfect quality!

  • canopy and cowl installed

  • aluminum landing gear ready to be attached

  • rudder servo tray glued in

  • bulkheads installed

  • fuel and smoke tank holders glued in

  • wings servo bays installed

  • predrilled location for control horns an all surfaces

  • predrill plates for different engines included

  • and, of course, a vast area in the fuselage when canopy latch removed.

Parts description:

​

Fuselage: vacuum sandwich with all bulkheads installed, including c/f inside canopy frame

​

Wings: vacuum sandwich. Aluminum wing tube 40mm, each panel needs 2 servos( JR 8711).

​

Elevators: vacuum sandwich. It can be taken apart if needed. Hinge wire is a brass tubing. Each half has one mount for JR 8711. Two alu tubes 10/1mm.

​

Rudder: vacuum sandwich. Hinge wire is a brass tube, removable on the bottom of the rudder needs to be removed for transportation.

Cowl: f/g part. Fitted to the fuselage and attached using 8 M4 screws. Any 80 - 120ccm size engine fit in without any problems.

​

Landing gear: alu, with all the holes predrilled. Wheel pants are f/g

​

Canopy hatch: 

  •   Alu/titanium look - comes with every kit, standard equipment.

  •   Carbon fiber - must be ordered extra, glued into canopy frame.                                                   

  • NOT RECOMMENDED TO  BE USED WITH 2.4Ghz.

  •   Clear ( transparent) - must be ordered extra. Glued into canopy frame.airframe

Canopy frame fitted on to fuselage from the factory. Use only two M4mm screws and two                wooden dowels.

bottom of page