DESCRIPTION

New AreS XL 3D jet kit is a result of development company KRILL Aircraft and Seba Silvestri with the main goal to offer a big 3D sport jet kit with ultimate flying characteristics for precise aerobatics and 3D aerobatics at the same time.

 

 

Size is set not to exceed European weight limit 25 kg – it means plane ready to fly with fuel+smoke.

 

​To achieve this, we designed the shape to extremely light frame (empty less than 9000 grams) with huge ailerons and flaps on central hinges, where flaps are possible to operate not only as a flap (flaps move in positive deflection) but by mixing with ailerons as an additional surface for ailerons.

The fuselage has a slim, flat, and tall shape for great stability during knife-edge flight. Elevators and rudder use central hinges as well.

 

The frame is very light but strong enough for extreme maneuvers at medium speeds.

For easier transportation you can dismantle fuselage into two pieces, the dividing line is behind the wings line and turbine. Wings, elevators, and fin with rudder are removable as well.

 

The plane is set up for Electron retracts, the special set is offered.

Front gear door is operated by a linear actuator controlled from retract controller or directly from receiver, hinges of front doors are installed.

 

Specially designed Kevlar tanks for kerosene and smoke are available, with tanks holder installed inside the fuselage, attaching is very easy with 4 screws, no additional work is needed.

 

 

Especially for this kit designed jet pipes are offered in 3 sizes and one with vectoring.

The kit:

  • 1 or 2 servos for each aileron

  • 1 servo for each flap

  • 1 servo for rudder and

  • 1 servo for each elevator

 

All servos must be at least 25 kg.

All control surfaces are pre-drilled with holes for Gabriel horns, that come with the kit as a standard.

 

Characteristics:

Wingspan:      2700 mm

Length:            3300 mm

Weight (dry):   19 kg

Recommended power setup: from P180Rx turbine